![]() It can be opened with Betaflight Blackbox Explorer software and the recorded flight data can be seen. LOG000 is the log file generated after unlocking this time. After each setting is completed, click the Save and Restart button.īlue light off: SD card detected, ready to workīlue light flashes quickly: it will only appear after the remote control is unlocked, and the black box normally writes the data returned by the flight controllerĮxport the LOG000 file of the SD card to the computer (the file serial number is automatically incremented by 1 each time the power is turned on), where the CFG file is the black box configuration file, this can be exported without. Enter the black box interface and select Serial Port, 2KHZ, GYRO_SCALED, (Black logging rate/mode are selected according to their actual needs). Here, UART7 is used as a demonstration, and Blackbox logging is selected, and the baud rate is 2000000. The BetaFlight ground station sets the port function of the external black box. ![]() Refer to the wiring diagram for the connection method. Connect the F4-openlager module and the flight controller correctly. I have deleted and reinstalled Betaflight multiple times as well as the drivers, including the Impulse RC driver. I feel as though I have tried everything. ![]() , Can not place large-capacity black box, so the open source F4-openlager high-speed serial port black box appeared. When I plug in my USB cable to my flight controller on all of my quads, the flight controller and the receiver power on, but Betaflight gives me an error message every time, stating, that it has failed to open the serial port. At present, many flight controllers do not have large-capacity black boxes, and the onboard is only 8-32MB, especially for many AIOs because of space constraints. Many pilots have become accustomed to using various black box data analysis software to adjust PID and filter parameters.
0 Comments
Leave a Reply. |